Instruction Manual

54 Rockwell Automation Publication 1408-UM001D-EN-P - September 2013
Chapter 5 Explicit Messaging
RSLogix5000 – Message Configuration Using PLC5 or SLC Typed
Read/Write
This is an example of how to set up a message instruction to read or write single
or multiple elements from a power monitor using PLC5 or SLC Typed messages.
This setup applies to ControlLogix and CompactLogix programmable logic
controllers.
Table 2 - Message Type
Read/Write Type Communication Read/Write Message Type
Single Element Serial SLC Typed
Single Element Ethernet PLC5 Typed or SLC Typed
Multiple Element Serial SLC Typed
Multiple Element Ethernet PLC5 Typed or SLC Typed or CIP Generic
(1)
(1) The CIP Generic message type is only available for RSLogix5000 software. All elements in the data table are written to or read back.