Instruction Manual

64 Rockwell Automation Publication 1408-UM001D-EN-P - September 2013
Chapter 5 Explicit Messaging
5. Enter the IP Address of the power monitor in the first row of the To
Address column.
Message setup is complete.
Reading Logs
You can perform explicit messages to read data from log records in the power
monitor.
For information on setting up explicit messages to the power monitor, please refer
to Explicit Message Setup – Examples
on page 53.
The following logs can be read into a controller depending on the logs supported
by your power monitor.
• Unit Status Log
• Min/Max Log
• Energy Log
• Load Factor Log
• Time of Use Log kWh
• Time of Use Log kVAR
• Time of Use Log kVA
Please refer to Appendix
A for the data table address of the specific log you are
requesting.