User Manual

Publication 1408-UM001B-EN-P - May 2008 27
Explicit Messaging Chapter 4
3. Choose the appropriate parameters in the Message
Configuration window.
Ethernet Network Communication
Serial Communication
Communication Type Parameter Choice
Ethernet Communication Command Select the appropriate message type according to
Message Type
on page 18.
Data Table Address (This Controller) Read: This is the controller tag in which to store the data
being read.
Write: This is the controller tag that stores the value to be
written to the power monitor.
Size in Elements This is the number of elements being read or written to. If
you are performing a single element read or write, then
this value should be 1. If you are performing a multiple
element read or write, then this should be the number of
elements after the source element that you wish to read or
write.
Port Number 2
Data Table Address (Target Device) Refer to Appendix
A for the address of the specific data
value you’re reading or writing to.
MultiHop Yes