Manual

16 Publication ICM-UM001C-EN-E - March 2013
Chapter 2 Install the Adapter
1. Connect the ControlNet network cable to connector A.
2. Connect the redundant ControlNet network cable to connector B.
3. Connect +V DC power to the lower connector, terminal F or D.
4. Connect -V common to the upper connector, terminal E or C.
WARNING
If you connect or disconnect the communications cable with
power applied to this module or any device on the network, an
electrical arc can occur. This could cause an explosion in
hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.
ControlNet XM Adapter
2
5
1440-ACNR
AB
A
BG
CE
DF
ATTENTION
When connecting wiring, torque terminal screws C, D, E, and F
to 0.8 Nm (7 lb-in).