Owner manual

Publication GMSI10-UM004B-EN-P - May 2010
Index 117
P
panel/wall mount grounding requirements 10
Parameter Object 92
poll message format 75
Assembly instance 101 76
Assembly instance 102 76
Assembly instance 103 76
power requirements 6
power supply, wiring 20
program mode 41, 71
R
relay contacts
normally closed
21
normally open 21
Relay indicator 43
Relay Object 101
relay parameters 53
Activation Delay 54
Activation Logic 55
Alarm A 55
Alarm B 55
Alarm Identifier A 55
Alarm Identifier B 55
Alarm Levels 56
Alarm Status to Activate On (Alarm Levels) 56
Enable 54
Failsafe 57
Latching 54
Name 54
Number 54
Relay Installed 56
relays
resetting
27, 43
wiring 21
remote relay reset signal, wiring 27
reset switch 43
reverse rotation mode 1
configuring 46
sensor placement 35
run mode 41, 71
S
self-test, status 43
sensor placement, reverse rotation 35
serial port connection
mini-connector
37
terminal base unit 36
single redundant channel mode 1, 46
specifications 65
Speed Measurement Object 104
Startup indicator 42
startup switch, wiring 29
switch input grounding requirements 13
switched buffered output, wiring 25
T
Tachometer Channel Object 106
tachometer parameters 47
Auto Trigger 49
Bias Current 48
DC Bias Time Constant 49
Fault High 48
Fault Low 48
Fault Time-Out 50
Name 47
Pulses per Revolution 50
Speed Multiplier 50
Tach Multiplier 50
Trigger Hysteresis 49
Trigger Mode 49
Trigger Slope 50
Trigger Threshold 50
terminal base
interconnecting units
15
mounting on DIN rail 13
mounting on panel/wall 16
terminal block assignment 18
transducer grounding requirements 12
Transducer Object 107
transducer wiring 29
magnetic pickup sensor 31
non-contact sensor 30
TTL output device 33
W
wiring
to separate power connections
6
to terminal base 17
wiring connections
4-20mA outputs
26
buffered outputs 24
DeviceNet 37
power supply 20
relays 21
remote relay reset signal 27