Manual

Publication GMSI10-UM013D-EN-P - May 2010
Index 203
grounding requirements (continued)
switch input 13
transducers 12
gSE mode 56
gSE parameters 69
FMAX 70
gSE Full Scale 70
High Pass Filter 70
Number of Averages 71
Number of Lines 70
Output Data Unit 70
Window Type 71
guidelines for setting full scale 191
I
I/O data parameters 88
Assembly Instance Table 88
COS Output 88
COS Size 88
Custom Assembly 88
Poll Output 88
Poll Response Assembly 88
Poll Size 88
I/O message formats
bit-strobe messages
115
change of state (COS) messages 114
poll messages 107
XM status values 114
Identity Object 120
indicators 49
Channel Status 51
Module Status 50
Network Status 51
Relay 51
Setpoint Multiplier 51
Tachometer Status 51
installation requirements
grounding
8
power 6
wiring 6
interconnecting terminal base units 15
introduction 1
invalid device configuration errors 106
K
keyswitch 48
M
measurement modes 56
conventional mode 56
gSE mode 56
Module Status (MS) indicator 50
mounting
terminal base unit on DIN rail
13
terminal base unit on panel/walll 16
XM-122 module on terminal base 48
N
Network Status (NS) indicator 51
node address 47
normally closed relay contacts 22
normally open relay contacts 22
Not1X measurements 90
O
operating mode
program mode
50, 103
run mode 50, 103
Overall Measurement Object 158
overall measurement parameters 63
Low Pass Filter 64
Overall Damping Factor 64
Overall Filter 64
Overall Time Constant 63
Signal Detection 63
P
panel/wall mount grounding requirements 10
Parameter Object 138
poll message format 107
Assembly instance 101 108
Assembly instance 102 109
Assembly instance 103 110
Assembly instance 104 111
Assembly instance 105 112
Assembly instance 106 113
power requirements 6
power supply, wiring 21
program mode 50, 103
R
relay contacts
normally closed
22
normally open 22