Installation Instructions User Manual

POINT I/O 8 Channel High Density Current Input Modules 11
Publication
1734-IN033B-EN-P - November 2010
Install the Removable Terminal Block (RTB)
A removable terminal block is supplied with your wiring base assembly. To
remove the terminal block, pull up on the RTB handle. This allows the
mounting base to be removed and replaced as necessary without removing
any of the wiring. To reinsert the removable terminal block, proceed as
follows.
1. Insert the end opposite the handle into the base unit. This end has a
curved section that engages with the wiring base.
2. Rotate the terminal block into the wiring base until it locks itself in
place.
3. If an I/O module is installed, snap the RTB handle into place on the
module.
Remove a Mounting Base
To remove a mounting base, you must remove any installed module, and the
module installed in the base to the right. Remove the removable terminal
block, if wired.
1. Unlatch the RTB handle on the I/O module.
2. Pull on the RTB handle to remove the removable terminal block.
3. Press on the module lock on the top of the module.
4. Pull on the I/O module to remove from the base.
5. Repeat steps 1, 2, 3 and 4 for the module to the right.
6. Use a small bladed screwdriver to rotate the orange locking screw to a
vertical position. This releases the locking mechanism.
7. Lift straight up to remove.