INSTALL INSTRUC MOLD PRESSURE Manual

Mold Pressure Module 5
3. Module I/O

level: range application:
low 2mV/V sensitivity mold pressure
4-20mA general purpose
-100 to +100mV bi-directional
high 0-10V hydraulic pressure
Summary Data Displayed on Your PC and Read by SLC in M0/M1 Files
injection cycle time
peak injection pressure
minimum cycle pressure
time to peak pressure
trigger time (off to on to off) for T1 (injection forward - fill, pack, and hold)
trigger time (off to on to off) for T2 (fill)
trigger time (off to on to off) for T3 (screw backup)
trigger time (off to on to off) for T4 (mold closed)
integral to peak pressure in units of PSIxSec
integral of trigger 1 (injection forward) in units of PSIxSec
integral of trigger 2 (fill) in units of PSIsec
integral of trigger 3 (screw backup) in units of PSIxSec
integral of trigger 4 (mold closed) in units of PSIxSec
integral of injection cycle in units of PSIxSec