User guide

Chapter 6
Creating a Program
6–8
13.From this display you may choose the data format you prefer to use to
configure the module for your application: BINary, DECimal,
HEXadecimal/Binary Coded Decimal. Refer to Remote I/O Scanner User
Manual, catalog number 1747–NM005, for a detailed description of the
configuration specifications.
14.When you finish configuring your specialty I/O module, press
[ESC] to
return to the previous display:
–––––– Advanced I/O Configuration ––––––
Current Subroutine File: 0
Current Configuration File: G6
F1 F2 F3 F4 F5
OFL
INT_SBR MOD_SET CFG_SIZ ADV_SIZ
The [F1], INT_SBR, interrupt subroutine number, designates the I/O
event-driven interrupt function that is used with the SLC 5/02 processor
only. This function allows a specialty I/O module to interrupt the normal
processor operating cycle in order to scan a specified subroutine file.
This is described in detail starting on page 31–1. Interrupt operation for a
specific module is described in the user’s manual for the module.
Naming the Ladder Program
In addition to configuring your controller, you must give the program a
name, other than DEFAULT, before continuing. When naming your ladder
program, the HHT allows only numbers and certain letters available on the
keypad, to be entered.
Important: Ladder program names may be created on an APS terminal
using the characters A–Z, 0–9, and underscore ( _ ). These
programs may be uploaded to and displayed on the HHT.
1. From this display:
File Name: Prog Name:DEFAULT
File Name Type Size(Instr)
0 System *
1 Reserved *
2 Ladder *
F1 F2 F3 F4 F5
CHG_NAM CRT_FIL EDT_FIL
OFL
MEM_MAP
DEL_FIL >