User guide

Hand–Held Terminal
Index
User Manual
I–9
mnemonic listing, 2–15
sequencer instruction, 15–7, 24–7
sequencer output (SQO)
mnemonic listing, 2–15
sequencer instruction, 15–7, 24–2
series logic, 5–4
service communications (SVC)
5/02 processor, 18–14
I/O message and communications
instructions, 15–3, 18–14
mnemonic listing, 2–15
specifications
certification, 1–1
communications, 1–1
compatibility, 1–1
dimensions, 1–1
display, 1–1
environmental, 1–1
humidity rating, 1–1
keyboard, 1–1
memory retention, 1–1
operating power, 1–1
square root (SQR)
5/02 processor, 20–20
math instruction, 15–5, 20–20
mnemonic listing, 2–15
status data file display, 12–6
status file, 27–1
functions, 27–2
status file display, 27–32
5/01 and fixed processors, 27–33
5/02 processors, 27–32
subroutine (SBR)
control instruction, 15–8, 25–6
mnemonic listing, 2–15
subtract (SUB)
math instruction, 15–5, 20–4
mnemonic listing, 2–15
series C or later 5/02 processor, 20–5
suspend (SUS)
control instruction, 15–8, 25–9
mnemonic listing, 2–15
T
table to locate instruction types, 15–9
temperature
operating, 1–1
storage, 1–1
temporary end (TND)
control instruction, 15–8, 25–8
mnemonic listing, 2–15
test mode, 11–2
continuous scan, 11–2
single scan, 11–2
the file indicator #, 4–16
timer and counter instructions, 15–2, 17–1
count down (CTD), 15–2, 17–7
count up (CTU), 15–2, 17–7
high–speed counter (HSC), 15–2, 17–9
reset (RES), 15–2, 17–13
retentive timer (RTO), 15–2, 17–5
timer off–delay (TOF), 15–2, 17–4
timer on–delay (TON), 15–2, 17–3
timer data file display, 12–8
timer off–delay (TOF)
mnemonic listing, 2–15
timer and counter instructions, 15–2, 17–4
timer on–delay (TON)
mnemonic listing, 2–15
timer and counter instructions, 15–2, 17–3
TOD, convert to BCD, math instruction,
20–12
troubleshooting, contacting Allen–Bradley,
P–5
troubleshooting faults
error codes, 28–2
status file fault display, 28–2
U
understanding I/O interrupts for 5/02
processor, 31–1
IID and IIE instructions, 31–6
INT instruction, 30–9
interrupt parameters, 31–4
operation, 31–2
RPI instruction, 31–9
understanding selectable timed interrupts for
5/02 processor, 30–1
operation, 30–1
STD parameters, 30–6
STE parameters, 30–6
STI parameters, 30–4
STS parameters, 30–8
understanding the user fault routine for the
5/02 processor, 29–1
application example, 29–5