User Manual

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 103
Configure Your Controller for DeviceNet Communication Chapter 7
Configure the Scanlist of the PanelView Scanner
Follow this procedure to configure the scanlist of the PanelView Plus DeviceNet
scanner.
1. Click the Scanlist tab.
2. Click the right arrow to move the SmartGuard controller to the scanlist.
3. Click Edit I/O Parameters and verify it is configured as shown below.
The example has a 4-byte polled connection that will be an input to the
PanelView Plus interface.
Because the Automap on Add was checked, the following mapping
occurred automatically.