User Manual

114 Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Chapter 7 Configure Your Controller for DeviceNet Communication
The example has a polled connection that will read 4 bytes and write 1
byte between the SmartGuard controller and the PanelView Plus interface.
Because the Automap on Add was checked, the following mapping
occurred automatically.
4. Verify that the 4 bytes of input data and the single byte of output data are
mapped as shown.
5. In RSNetWorx software, right-click the PanelView Plus interface and
choose Download to Device to download this configuration to the
PanelView Plus interface.