User Manual

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 147
Create Your Application Program Chapter 10
Figure 37 - In/Out Setting Tab
Number of Inputs
The number of inputs for logic functions can be increased or the optional input
to function blocks can be enabled.
Number of Outputs
The number of outputs for logic functions can be increased or the optional
outputs, such as error outputs, from function blocks can be enabled.
Fault Present Bit
You can enable the Fault Present diagnostic-status bit in some function blocks by
selecting the checkbox located on the In/Out Setting tab of the Function Block
Properties dialog box. If the Use Fault Present checkbox is checked, an additional
Fault Present output is displayed on the function block.
Optional Output Point Selections
You can enable optional outputs, including the Fault Present bit for some
functions blocks, by checking the appropriate checkboxes on the Out point tab of
the Function Block Properties dialog box. When the optional outputs are
checked, they are displayed on the function block.