Manual

Publication 1756-UM522B-EN-P - February 2003
4-6 Installing the Drive Module
Figure 4.3 Drive Comm - PMI Processor Connections
Refer to See Table 1.C on page 1-3 for information on available
pre-configured fiber optic Drive Comm cables.
Removing the Module
1. Push in the top and bottom locking tabs.
2. Pull the module out of the chassis as shown.
C
O
M
M
XMT
RCV
ATTENTION
!
Before you remove the module, you must disconnect
the fiber optic cables.
TIP
If you kept the plugs that were removed to
connect the fiber optic cables, reinsert them to
protect the ports.