Configuration Manual Owner manual

Publication 1757-PM002A-EN-E - June 2006
Applications 4-19
4. Click OK.
A blue line is added to the AI block to represent the incomplete link.
5. Click the LGX Block to complete the link.
Hold <Ctrl> to draw straight lines.
The Input Parameter Selection window opens.
6. Select the IN_0 pin and click OK.
A link is drawn from the AI block to the LGX block.
7. Click the LGX block again.
8. Select the OUT_0 pin and click OK.
9. Click the AO block to complete the Link.
10. Select the CAS_IN pin and click OK.
A link is drawn from the PID block to the AO block.
11. Click the Link button and select the AO block again.
12. Select the BKCAL_OUT pin and click OK.
13. Click below the block, move the cursor under the Logix block, and click
again.
A segmented line is drawn.
14. Click the LGX block to complete the Link.