Installation and Upgrade Guide Owner's manual

1 Publication 1757-IN040B-EN-P - March 2002
Chapter 8
Supplementary Procedures
Stopping ProcessLogix
Applications and Services
Use the following procedure to exit all ProcessLogix applications and
stop all ProcessLogix services.
1. Exit all running ProcessLogix applications, such as Control
Builder, Station, and Network Tools (NTOOLS).
ATTENTION
!
Before installing or uninstalling any software
component, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services.
IMPORTANT
If you have redundant servers, you must complete
this procedure on the SERVERB node first. Then
complete the entire procedure again for the
SERVERA node.