Installation and Upgrade Guide Owner's manual

Publication 1757-IN040B-EN-P - March 2002
Supplementary Procedures 8-31
•
Navigate in Knowledge Builder to Control Builder Components
Theory
⇒Controller Redundancy Functionality before upgrading
to a Redundant Chassis Pair for general information about
Controller redundancy and related terminology.
•
Navigate in Knowledge Builder to Control Hardware Installation
Guide
⇒Controller Module Installation and Removal for
information on installing the 1757-PLX52 module.
•
Navigate in Knowledge Builder to Control Hardware Installation
Guide
⇒Redundancy Module Installation and Removal for
information on installing the 1757-SRM module.
•
Navigate in Knowledge Builder to Control Hardware Installation
Guide
⇒ControlNet Communication Module Installation and
Removal for information on installing the 1756-CNB module.
Updating Firmware Revision Levels
Refer to Upgrading Hardware Component Firmware on page 7-4 to
check/upgrade 1757-PLX52, 1756-CNB, and 1757-SRM firmware.
Creating a Redundant 1757-PLX52
1. Create redundant CPMs
Navigate in Knowledge Builder to Control Building
Guide
⇒Hardware Module Creation⇒Creating a Control
Processor Module for more information about configuring a
redundant 1757-PLX52 in Control Builder.
2. Create redundancy modules.
Navigate in Knowledge Builder to Control Building
Guide
⇒Hardware Module Creation⇒Creating Redundancy
IMPORTANT
Stop! It is essential that you check the firmware
revision levels for ALL ProcessLogix hardware
components after a ProcessLogix software
installation.
Do not proceed until you have upgraded the
firmware.