Installation and Upgrade Guide Owner's manual

Publication 1757-IN040B-EN-P - March 2002
Operating System Installation Procedures 2-39
Converting to NTFS after Installing Windows NT
If the PC is currently using a FAT file system, use the following
procedure to convert to the NTFS file system. The ProcessLogix Server
software must run on a PC using the NTFS file system.
1. Click Start
⇒Run.
2. Key in this command in the Open entry field:
>cmd<
and click OK to open the DOS window.
3. At the DOS prompt, key in this command:
>CONVERT C: /FS:NTFS<
and press <Enter> (where C: is the drive upon which the
ProcessLogix Server software will be installed).
4. Wait for the conversion to complete. Exit the DOS window.
5. Restart the PC.
Creating the ps_user Account
1. Close all running applications.
2. Click Start
⇒Programs⇒Administrative Tools (Common)⇒User
Manager.
3. Select Administrator in the Username list box. Click User
⇒Copy.
4. Enter the appropriate information for ps_user from Table 2.B on
page 2-26.
5. Check ONLY the Password Never Expires checkbox and click
OK.
6. Close the User Manager window.
7. Log off the PC and logon as ps_user.
Installing Internet Explorer 5.5 SP 1
Refer to Installing Internet Explorer 5.5 SP1 on page 2-19.