Installation and Upgrade Guide

Publication 1757-IN510A-EN-P - October 2003
4-32 ProcessLogix Server Upgrade Procedures
Transferring the 1784-PCIC
Card to the R510.0 System
The following procedure describes how to transfer the 1784-PCIC card
from your R320.0 system to an R510.0 system.
1. If your R510.0 system already contains an 1784-PCIC card, skip
to Restoring ProcessLogix Data on page 4-35.
2. Shut down and turn the power off to both the R320.0 and R510.0
Server(s).
3. Remove the 1784-PCIC card from the R320.0 Server and insert it
into the R510.0 Server. Refer to the 1784-PCIC Installation
Instructions, Publication 1784-IN003A.
4. Turn on the R510.0 Server.
5. Logon to the R510.0 Server as ps_user.
6. If the Found New Hardware Wizard opens, skip to step 11. If the
Found New Hardware Wizard does not open, continue with
Step
7.
7. Right-click the My Computer icon and select Man age.
8. Select Device Man ager.
9. Under Other Devices, right-click the PCI device and select
Pr oper ties.
10. On the Driver tab, click Up d ate Dr iv er .
11. Click Ne x t .
12. Select the Search for a suitable driver option and click Ne x t .
13. Check only the Specify a location checkbox and click Ne x t .
14. Insert the ProcessLogix R510.0 Application Software CD into the
CD-ROM drive.
ATTENTION
!
You must turn the power off to both systems before
attempting to transfer hardware. Failure to do so
could result in hardware damage.