Installation and Upgrade Guide

Publication 1757-IN510A-EN-P - October 2003
7-18 Firmware Maintenance Procedures
10. Check Yes, I want to launch ControlFLASH and click Fin is h .
11. At the Welcome to ControlFLASH window, click Ne x t .
12. Click 1757-ABRIO and click Ne x t .
13. Expand RSLinx Tree window to the location of the 1757-ABRIO
module you wish to flash.
14. Select the module icon and click OK.
15. Confirm that the new revision for this update is 1.2 and click
Ne x t .
16. At the Summary window, click Fin ish .
17. Click Yes to confirm the flash.
18. Click OK.
If this update is successful, the Update Status window displays
the following message in green: Update Complete. Please verify
this new firmware update before using the target device in its
intended application.
19. Click OK and then click Cancel at the Welcome to
ControlFLASH Setup window.
20. Click Yes to end the configuration session.