Installation and Upgrade Guide

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Server Upgrade Procedures 4-13
9. Close EvMove.
10. Remove the Master Disk and store it in a safe place.
Preparation for a ProcessLogix R400.0 SP2 or R500.1 to R510.0 Server
Upgrade is complete.
Return to the checklist that led you to this task.
Saving R400.0 SP2 or R500.1
Data to a Remote PC
Networking an R400.0 SP2 or R500.1 Server to a Remote PC
Use the following procedure to map a drive to a remote PC. If you
have a redundant server pair, you must complete this procedure on
SERVERB first. Then complete the entire procedure again on
SERVERA.
1. If necessary, logon to the R400.0 SP2 or R500.1 Server as
ps_user.
2. Click Star t ⇒ Run .
3. Enter >cmd< and click OK to open the DOS window.
4. Enter >NET USE T: \\STN01\C$ /user:ps_user<
(where STN01 is the remote PC name and ps_user is the user
currently logged on to STN01) and press <Enter>.
5. If prompted, enter the appropriate password.
6. Open Windows Explorer and verify that the T: drive exists.