Owner manual

Index
I–2
HART Protocol communication error codes,
B3
I
inputs
commandspecific, 33
standard, 33
installing the STT, 21
copy STT subroutine to disk, 22
create and name a new program file,
23
paste the STT program file, 24
save the new STT program file, 25
integer word 30, STT subroutine status,
34
J
JSR instruction, 35
L
ladder logic, 35
long frame addressing, 11
N
naming the STT program file, 23
O
outputs
commandspecific, 36
standard, 36
P
packets
HART, 15
Smart Transmitter Interface, 15
pasting STT program file, 24
PLC5 processors, 11
R
read dynamic variables & PV current, A6
read primary variable, A4
read unique identifier, A2
related publications, iii
reset configuration change flag, A10
S
saving STT file, 25
set primary variable to zero, A12
short frame addressing, 11
Smart Transmitter Interface error codes,
B2
Smart Transmitter Interface packet, 15
Smart Transmitter Toolkit, features, 11
software, 13
6200 programming, 13
ControlView, 11
Cornerstone, 11
standard inputs, 33
standard outputs, 36
STT done bit, 34
STT enable bit, 34
STT enter/exit bit, 34
STT error bit, 34
STT subroutine error codes, B1
STT subroutine status word 30, 34
STT trigger bit, 34
T
terms, ii
U
unit codes, B5
using the STT subroutine, enter a JSR,
35
using this manual, ii
W
write PV range values, A8
write PV units, A14