User Manual Owner manual

Numbers
115V operation, 213
1747C11 cable, 24
1771KGM, 41, 45
230V operation, 214
A
active node table, B3, B4
address conversion, 44
advanced communication parameters, 37
B
back panel, 21
basic communication parameters, 35
baud rates, A1
buttons, 31, 32
C
cable
constructing, 22
length, 12
cable connector, A1
cabling considerations
DH485, 22
modem, 212
RS232C, 28
chassis ground, 28, 29
clear to send (CTS), 28
command format
diagnostic counter reset, B5
diagnostic loop, B1
diagnostic read, B2
diagnostic status, B4
read link parameters, B6
set link parameters, B6
SRD request, 48
command set, 46
communicating with a modem, 49
communication driver, 41
communication parameters, 31, 32
advanced, 37
basic, 35
configuration display and push buttons,
31, 32
configuration mode, 31
configuring the KF3, 31, 33
connection
between a KF3 and a modem, 212
between two intermediate nodes, 26
for first segment of a multidrop network,
26
for the last segment of a multidrop
network, 27
to IBM computer with handshake signals
25 pin, 211
9 pin, 211
connectors, 21
constructing cables, 22
CTS, 28
CTS to transmit delay, 39
current setting, 32, 33, 35
D
data button, 32
data carrier detect (DCD), 28, 49
data rate, 12
data set ready (DSR), 28, 49
data terminal ready (DTR), 28, 49
DCD, 28, 49
default settings, 31, 35, 37, 43
destination address, 41, 42, 43
DF1 ACK timeout, 38
DF1 communication, 41
DF1 device category, 36
DF1 protocol, 11, 12, 41
DH485, 12, 21, 22, 41
activity indicator (LED), 310, 51, 52
baud rate, 35
cabling considerations, 22
Communication Interface, 11
master devices, 46
network, P1
node address, 35
slave devices, 46
DH485 specifications, A1
diagnostic commands, 35, B1
Index