Installation Instructions Manual
Analog Output Module10
2!)(" 1(,+ "1,!$/
The 1771–OFE modules are a modular component of the 1771 I/O
system requiring a properly installed system chassis. Refer to
publication 1771–IN075 for detailed information on acceptable
chassis and proper installation and grounding requirements. Limit
the maximum adjacent slot power dissipation to 10W maximum.
Connect your I/O devices to the cat. no. 1771-WC wiring arm
shipped with the module.
!
Remove power from the 1771 I/O chassis
backplane and field wiring arm before removing
or installing an I/O module.
• Failure to remove power from the backplane or
wiring arm could cause module damage, degra-
dation of performance, or injury.
• Failure to remove power from the backplane
could cause injury or equipment damage due to
possible unexpected operation.
!
WARNING
If you connect or disconnect wiring with
field–side power is on, an electrical arc can occur.
This could cause an explosion in hazardous
location installations. Be sure that power is
removed or the area is nonhazardous before
proceeding.
' ++$) ,21-21 )$ #
' ++$) ,21-21 6 )$ #
' ++$) ,21-21 )$ #
' ++$) ,21-21 6 )$ #
' ++$) ,21-21 )$ #
' ++$) ,21-21 6 )$ #
' ++$) ,21-21 )$ #
' ++$) ,21-21 6 )$ #
,1 20$#
,1 20$#
0$/ + ),& $3("$
($)# (/(+& /*
1 , 6
2+"1(,+ )
/,2+#
'$ 6 *,#2)$ #,$0 +,1 02--)5 ),,- -,4$/ %,/
),,-6-,4$/$# + ),& #$3("$0 1/ +0*(11$/0 1/ +0#2"$/0 $1"
,,- -,4$/ *201 !$ 02--)($# !5 1'$ 20$/
0$/602--)($# ),,- -,4$/
(% /$.2(/$#
0$ $)#$+ 0'($)#$# " !)$ %,/ 0(&+ ) 1/ +0*(00(,+ 1, 1'$
+ ),& #$3("$0 '(0 " !)$ ",+0(010 ,% 0(+&)$ (+02) 1$#
14(01$#6- (/ ,% ",+#2"1,/0 ",3$/$# ),+& 1'$(/ $+1(/$ )$+&1' !5 %,()
0'($)# +# $+" 0$# (+ -) 01(" '$ 0'($)# /$#2"$0 1'$ $%%$"1 ,%
(+#2"$# +,(0$ 1 +5 -,(+1 ),+& 1'$ " !)$