Installation Instrucitons Owner manual

Install the 1784-PKTCS Card 2-3

Publication 1784-IN042A-EN-P - April 2005

4. Turn on the computer to be certain that it comes up correctly.

Connect to the Network

After you have installed the card, you can connect it:

• dire

ctly to a ControlNet network, which requires a tap (page 2-5)

• to a device already connected to the ControlNet network (page 2-6)

See Figure 2.1 on page 2-4 for the connectors and indicators.

If the computer: then:

powers up go on to the next section, Connect to the Network , on page 2-3

hangs up either the card is not seated correctly in the PCI slot or you have a

mory or I/O conflict. You should:

• re

move and reinsert the card into the same PCI slot and

try again

• r

emove and reinsert the card into a different PCI slot and

try again

• r

emove all other non-essential cards and try again

If you continue to experience difficulty, contact your local

Rockwell Automation sales representative or distributor, or call

Rockwell Automation Technical Support at 440.646.5800.

WARNING

If you connect or disconnect the ControlNet cable with power applied

to this module or any device on the network, an electrical arc can

occur. This could cause an explosion in hazardous location

installations.