User Manual User guide

Rockwell Automation Publication 193-UM012B-EN-P - June 2011 57
Chapter 5
Email Notifications
Introduction
This chapter describes email notifications and how to configure an E1 Plus
EtherNet/IP module to send email notifications for different events.
Notification Events
There are several events that can trigger an email notification; the events are listed
below.
• Overload trip
• Phase loss trip
• Jam trip
• Tri p c l e a r
• Overload warning
• Jam warning
• Underload warning
• Communication fault warning
• Communication idle warning
• EEPROM fault warning
• Warning clear
Email Contents
The subject and body contents in the email message will be created from the type
of trip or warning that is detected, the Device Name, Device Description, Device
Location and Contact Info. Sample email messages are shown here:
IMPORTANT
If an event has been disabled within the Control Supervisor Attribute
108 or 109 (see page 90
), it is not possible to override this and have
emails generated.
Email Subject
E1Plus module has detected a trip
Email Body
Trip status: Overload
Device Name: E1 Plus EtherNet/IP Side Mount Module
Device Description: Module under development
Device Location: The Location
Contact Info: Contact Person
[e-mail]