User Manual User guide

64 Rockwell Automation Publication 193-UM012B-EN-P - June 2011
Chapter 6
Parameter Group Listing
The E1 Plus EtherNet/IP Module contains five parameter groups
Monitor Group
Table 6 - Parameter Groups
Monitor parameters Advanced Setup Reset/Lock I/O Setup Trip History
1 Average %FLA 12 Trip Enable 14 Trip Reset 34 OutA Pr FltState 5 Trip Log 0
2%Therm Utilized 13 Warning Enable 24 Program Lock 35 OutA Pr FltValue 6 Trip Log 1
3 Trip Status 15 Single/Three Ph 25 Set to Default 36 OutA En FltState 7 Trip Log 2
4 Warning Status 16 OL Reset Mode 37 OutA En FltValue 8 Trip Log 3
10 Device Status 17 OL Warning Level 38 OutA En IdlState 9 Trip Log 4
18 Jam Inhibit Time 39 OutA En IdlValue
19 Jam Trip Delay 40 IN1 Assignment
20 Jam Trip Level 41 IN2 Assignment
21 Jam Warn Level
22 UL Inhibit Time
23 UL Warn Level
Average %FLA Parameter No. 1
This parameter reports the average motor current.
The value is reported as a percentage of motor
rated current (dial setting on the E1 Plus Overload
Relay), and is reported in increments of 5.
Access Rule Get
Data Type UINT
Units %
Min. Value 0
Max. Value 1275
Default Value 0
Tag Name Average_%FLA
% Therm Utilized Parameter No. 2
This parameter reports the percent thermal
utilization of the connected motor.
Access Rule Get
Data Type USINT
Units %
Min. Value 0
Max. Value 100
Default Value None
Tag Name %_Therm_Utilized