Installation - A4 Size Owner's manual

A-4 Specifications
Drive Ratings and Protection Devices Catalog Number Designations
The first three characters of the drive catalog numbers in the tables on the
following pages designate the type of drive control. The information in the
tables are valid for PowerFlex drives with both the 700H and 700S control.
Therefore, the third character of the drive catalog number in each table is
replaced with an “x”. For ordering purposes, drives with the 700H control
are designated as “20C” and drives with the 700S control are designated as
“20D”.
Feedback Encoder Inputs (2): Dual Channel Plus Marker, Isolated with differential transmitter
Output (Line Drive) Incremental, Dual Channel Quadrature type
Encoder Voltage Supply: 5V DC or 12 V DC 320 mA/channel
5V DC minimum high state voltage of 3.0V DC, maximum low
state voltage at 0.4V DC
12 V DC minimum high state voltage of 7.0V DC, maximum low
state voltage of 0.4V DC
Encoder PPR Rating: Encoder PPR ratings are limited to the values specified in the
table below:
Maximum Required Input Frequency: 400 kHz
Hi-Resolution Stegmann Option:
Refer to specifications on page C-1
Encoder Voltage Supply: 11.5V dc @ 130 mA
Hi-Resolution Feedback: Sine/Cosine 1V P-P Offset 2.5
Maximum Cable Length: 182 m (600 ft.)
RS-485 Interface: Hi-Resolution Feedback Option card obtains the following
information via the Hiperface RS-485 interface shortly after
power-up: Address, Command Number, Mode, Number of turns,
Number of Sine/Cos cycles, Checksum
Customer-I/O Plug (P1) - Hi Res: Allen-Bradley PN: S94262912
Weidmuller PN: BL3.50/90/12BK
Resolver Option:
Excitation Frequency: 2400 Hz
Excitation Voltage: 4.25-26 Vrms
Operating Frequency Range: 1 - 10 kHz
Feedback Voltage:
2V ± 300 mV
Maximum Cable Length: 304.8 meters (1000 ft.)
DriveLogix User Available MemoryBase:
With Memory Expansion Board:
256 kbytes
768 kbytes
Battery: 1756-BA1 (Allen-Bradley PN 94194801) 0.59g lithium
Serial Cable: 1761-CBLPM02 to 1761-NET-AIC
1761-CBLPA00 to 1761-NET-AIC
1756-CP3 directly to controller
1747-CP3 directly to controller
category 3 (2)
Flex I/O Connection: Up to (8) modules
FLEXBUS Current Output: 640 mA maximum @ 5.1V dc
Cable: 4100-CCF3
Category Specification PowerFlex 700H PowerFlex 700S
n = 2
n
= x mod 75 mod 125 mod 225 mod 375 mod 625
mod112
5
01 75 125 225 375 625 1125
12 150 250 450 750 1250 2250
24 300 500 900 1500 2500 4500
38 600 1000 1800 3000 5000 9000
4 16 1200 2000 3600 6000 10000 18000
5 32 2400 4000 7200 12000 20000 --
6 64 -- -- -- -- -- --
7 128 -- -- -- -- -- --
8 256 -- -- -- -- -- --
9 512 -- -- -- -- -- --
10 1024 -- -- -- -- -- --
11 2048 -- -- -- -- -- --
12 4096 -- -- -- -- -- --
13 8192 -- -- -- -- -- --
14 16384 -- -- -- -- -- --