Instruction Manual

ManualsBrandsRockwell Automation ManualsEquipment20D PowerFlex 700S AC Drives with Phase II Control Programming Manual

100

Table Of Contents

Rockwell Automation Publication 20D-PM001C-EN-P - July 2013 91

Programming and Parameters Chapter 2

514 Test Mode Config

Configures the Motor Control (MC) test mode.

Note: This parameter was changed to non-linkable for firmware version 3.001.

515 FVC Tune Config

Configures FOC tuning mode.

• Bit 1 “FluxCurrTune” when set, the value in Par 488 [Flux Current] is used as the flux current at the beginning of the magnetic inductance test. When this bit is not set (default), an automatically

calculated (preset) flux current is used as the flux current at the beginning of the magnetic inductance test.

• Bit 2 “NoTimeLimit” when set, the time limit fault detection during the magnetizing inductance test is disabled.

Note: Bits 1 and 2 were added for firmware version 4.001.

516 FVC2 Tune Config

Configures FOC 2 tuning mode.

No. Name

Description

Values

Linkable

Read-Write

Data Type

ATTENTION: Do not modify this parameter. Motor/Drive instabilities and damage may result.

Options

Reserved

ReflWave Comp

BusGain Comp

Reserved

Default xxxxxxxxxxxxxxxxxxxxxx11xxxxxxxx

Bit 313029282726252423222120191817161514131211109876543210

0 = False

1 = True

ATTENTION: Do not modify this parameter. Motor/Drive instabilities and damage may result.

Options

Reserved

NoRotateTune

Reserved

NoTimeLimit

FluxCurrTune

Reserved

Default xxxxxx0xxxxxx00x

Bit 1514131211109876543210

0 = False

1 = True

ATTENTION: Do not modify this parameter. Motor/Drive instabilities and damage may result.

Options

Reserved

NoRotateTune

Reserved

Default xxxxxx0xxxxxxxxx

Bit 1514131211109876543210

0 = False

1 = True