User manual

Configuring the WIM 3-9
1. From the drive StatusMonitor screen (Figure 3.9), tap the Port menu
and select the drive port to which the WIM is connected. For this
example, Port 1 is selected (Figure 3.15
) because the WIM is
installed in the drive’s bottom RJ-45 port. The WIM StatusMonitor
screen (Figure 3.16
) appears.
2. On the WIM StatusMonitor screen (Figure 3.16
), tap the stylus on
the white area above the “22-WIM-Nx” catalog number to display
the User Text entry screen (Figure 3.17
). In the text box, enter the
desired name for the WIM (for example, Pump 1 shown in
Figure 3.18) and tap OK. The WIM StatusMonitor screen reappears
with the entered name.
3. For the entered name to be recognized on the network, either reset
the WIM or power cycle the drive. Then re-establish wireless
communication between the WIM and Pocket PC.
Figure 3.15 Port Selection Screen Figure 3.16 WIM StatusMonitor Screen
Figure 3.17 User Text Entry Screen Figure 3.18 Pump 1 Screen