User Manual FRN 6.xx Manual

3-8 Programming and Parameters
Basic Program Group
P031 [Motor NP Volts] Related Parameter(s): d004, A084
Stop drive before changing this parameter.
Set to the motor nameplate rated volts.
Values Default Based on Drive Rating
Min/Max: 20/Drive Rated Volts
Display: 1 VAC
P032 [Motor NP Hertz] Related Parameter(s): A084, A090
Stop drive before changing this parameter.
Set to the motor nameplate rated frequency.
Values Default 60 Hz
Min/Max: 10/240 Hz
Display: 1 Hz
P033 [Motor OL Current] Related Parameter(s): P043, A055, A089, A090, A098, A114
Set to the maximum allowable motor current.
The drive will fault on an F7 Motor Overload if the value of this parameter is exceeded by 150% for 60
seconds.
Values Default Based on Drive Rating
Min/Max: 0.0/(Drive Rated Amps × 2)
Display: 0.1 Amps
P034 [Minimum Freq] Related Parameter(s): d001, d002, d013, P035, A110, A112, A115
Sets the lowest frequency the drive will output continuously.
Values Default 0.0 Hz
Min/Max: 0.0/240.0 Hz
Display: 0.1 Hz
P035 [Maximum Freq]
Related Parameter(s): d001, d002, d013, P034, A078,
A111
, A113, A115
Stop drive before changing this parameter.
Sets the highest frequency the drive will output.
Values Default 60 Hz
Min/Max: 0/240 Hz
Display: 1 Hz