User Manual Manual

1 Publication 2706-UM017C-EN-P - March 2006
Chapter 2
Install InView Communication Modules
Mount Module to 2706-P42,
2706-P43 and 2706-P44
Displays
The InView communication module is designed to mount to the track
of the InView 2706-P42, 2706-P43 and 2706-P44 displays.
1. Align the tabs on the back plate of the module to the track on
the display.
2. Tighten mounting screws until they bottom out against the back
plate.
Wire Communication
Module to InView Display
2706-P42, 2706-P43,
2706-P44
Below is an illustration and description of the InView communication
module and its connectors with relation to an InView 2706-P4x
display.
Wire Communication Module to InView Display
For ease in mounting, rotate
module 90° so that the
mounting holes are on top and
bottom. Rotate the module
clockwise over track until the
alignment is horizontal.
TB1
To TB1
To Controller
(Customer Supplied
Cable)
NEMA Type 12 Enclosure with Removable Cover
Torque Enclosure Cover screws to 0.68 Nm (6 in-lb).
Customer-supplied cable
through NEMA-rated cable
grip (supplied)
Back of InView Display (P42, P43, P44)
Serial cable to be
connected to terminal
block inside power supply
cover on back of InView
display. Cable to be
routed through cable grip
(supplied).
2706-P_M