User Manual Owner's manual

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 339
StepLogic, Basic Logic and Timer/ Counter Functions Appendix E
StepLogic Parameters
Digits 0…3 for each (StpLogic x) parameter must be programmed according to
the desired profile.
Digit 0Digit 1Digit 2Digit 3
1F00
Table 53 - Digit 0 and Digit 1 Settings
Setting Description Logic
0 Skip Step (jump immediately). SKIP
1 Step based on the time programmed in the respective (StpLogic Time x) parameter. TIMED
2 Step if Logic In1 is active (logically true). TRUE
3 Step if Logic In2 is active (logically true). TRUE
4 Step if Logic In1 is not active (logically false). FALSE
5 Step if Logic In2 is not active (logically false). FALSE
6 Step if either Logic In1 or Logic In2 is active (logically true). OR
7 Step if both Logic In1 and Logic In2 is active (logically true). AND
8 Step if neither Logic In1 or Logic In2 is active (logically true). NOR
9 Step if Logic In1 is active (logically true) and Logic In2 is not active (logically false). XOR
A Step if Logic In2 is active (logically true) and Logic In1 is not active (logically false). XOR
b Step after (StpLogic Time x) and Logic In1 is active (logically true). TIMED AND
C Step after (StpLogic Time x) and Logic In2 is active (logically true). TIMED AND
d Step after (StpLogic Time x) and Logic In1 is not active (logically false). TIMED OR
E Step after (StpLogic Time x) and Logic In2 is not active (logically false). TIMED OR
F Do not step OR no jump to, so use Digit 0 logic. IGNORE
Table 54 - Digit 2 Settings
Setting Logic
0Jump to Step 0
1Jump to Step 1
2Jump to Step 2
3Jump to Step 3
4Jump to Step 4
5Jump to Step 5
6Jump to Step 6
7Jump to Step 7
8 End Program (Normal Stop)
9 End Program (Coast to Stop)
A End Program and Fault (F2)