Manual

Editing Programs On Line
Chapter 5
5-36
If you press: It:
{STORE
END PT}
does not returnthe controlto theprogram displayscreen.
Pressing this softkey insertsthe generatedblock at whatever
location the cursor waslast at and allowsthe operator to
immediately beginentering thenext block usingthis same
digitize feature.
{EDIT &
STORE}
returns thecontrol tothe program displayscreen. The
program blockjust generated isdisplayed onthe input lineof
the CRT and may beedited asdiscussed in section 2.10. This
block isthen insertedat the locationof the block cursor when
you press the [TRANSMIT] key.
Important: Before pressing the {STORE END PT} or {EDIT & STORE}
softkey, press the exit {Ý} softkey to abort the circular digitize operation.
The control returns to softkey level 4. Then, select either another digitize
feature (by pressing one of the softkeys) or the control can return to the
regular edit session (as described on page 5-4) by pressing the exit {Ý}
softkey.
To delete part programs stored in memory:
CAUTION: Once you delete a program from memory, it can
not be recovered. Abort the delete program operation by
pressing the {DELETE NO} softkey.
1. Press the {PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
5.5
Deleting A Program
{DELETE}