QUICK START CONTROLNET MESSAGE Manual

ControlNet Message/Traffic Generator Tool 13
Publication 9220-10.1 — July 1996
Sending Unconnected Messages
Y ou can send unconnected messages to:
• send predefined unconnected messages
• get attribute information on an object
• reset a device
Sending Predefined Unconnected Messages
To send an unconnected message, choose Unconnected, Send Message,
and choose the message you want to send.
To
Choose this message

set the target nodes in the Listen Only mode CNet Listen Only
send Keeper type messages when not in an operating network Keeper 5ms, 15, 16
obtain loose parameters information Keeper Loose Params
obtain the pending parameters CNet Get Pending
obtain the current parameters CNet Get Current
obtain diagnostic information CNet Get Diags

These messages are defined in the tool’ s configuration file, CNXOR.CFG.
Getting Attribute Information
To send an unconnected message to get attribute information, choose
Unconnected, Get Attr All, and choose the object you want attributes on.