User Manual User guide

Preface
APS Import/Export Utility User Manual
5-30
FORCE I:4
% ON % % OFF %
% I:4.0 % 0x0000 0x0001
% I:4.1 % 0x0000 0x0010
% I:4.2 % 0x0003 0x0000
In this example, the force address “FORCE...O:7.4” skips over the first four words
of slot seven and forces bit O:7.4/0 off and bit O:7.5/8 on.
FORCE ...O:7.4
% ON % % OFF %
% O:7.4 % 0x0000 0x0001
% O:7.5 % 0x0100 0x0000
Specifying the Channel Configuration Data List
(SLC 5/03 and SLC 5/04 Processors Only)
The required format for specifying the channel configuration data list consists of the
keyword “CHAN_CONFIG” and a channel configuration file type. For example:
CHAN_CONFIG
GEN
Keyword Channel Configuration Type
You can also specify a value list, which contains the channel configuration
information for the specified channel configuration file. If you leave the list empty,
APSIE initializes a default channel configuration file.
Note While the APSIE utility verifies that the driver (as encoded as the low byte of the
first wor d) is corr ect for the channel, it does not verify (range check) that the other
fields ar e corr ect.
You can also set the channel configuration file to a default driver configuration. To
do this, use the default driver keyword entry.