Installation Instructions User guide

8
Bul. 937C Universal Frequency Converter Installation Instructions
Display modes and error messages
The current measurement value is shown on the display in normal operating mode. On selecting the
unit, Refer to Units.
If restart inhibit (Refer to Restart inhibit) has been triggered, but the device is still working in normal
mode, a message to that effect appears in the second line of the display.
If a malfunction occurs, one of the following messages is displayed (during appropriate parameterization)
until the malfunction is eliminated:
•
Err Device error
• Err LB for an lead breakage
• Err SC for a short circuit
On selecting error messages Refer to Display modes and error messages. The
switch outputs always revert to a no-current state when there is a malfunction.
Configuring Device Data
WARNING: A change in device data will change the operation of the device!
WARNING: Before ente
ring new data into the device, you should therefore as certain that no danger to the
installation will result.
FDT Interface
This manual describes Parameterization mode of the universal frequency converter using the control panel. parameterization mode
for the universal frequency converter is more convenient with a PC using Field Device Tool (FDT) software.
Some specialized functions can only be selected using the FDT , for instance, pulse suppression as an alternative to the start-up
override.
The FDT interface is the specification describing the standardized data exchange between devices and control system or engineering
or asset management tools. Examples include: PACTware
TM
, FieldCare, FactoryTalk AssetCentre, and Process Device Configuration.
FDT frame software can be downloaded from the web: www.pactware.com www.fdtgroup.org.
PACTware
TM
is trademark of PACTware Consortium