Design Installation Guide Owner's manual

Publication DNET-UM072C-EN-P - July 2004
6 Index
output devices
minimum required operating voltage
1-1
powering 1-1
output power
hydraulic solenoid valves
1-1
motor starter coils 1-1
noise or transient protection 1-2
pneumatic valves 1-1
P
parallel application
power supplies
1-16
pluggable screw-connector
installation
3-2
plug-in
connector
open-style
1-10
pneumatic valves
output power
1-1
power
determining
using look-up method
1-18, 4-3
limitations 1-1
power cable
diagram
KwikLink
3-15
KwikLink
installation
3-15
power conductors
NEC regulations
4-2
power supplies
adjusting
4-15
choosing 1-15
Class 2 1-1
connecting 3-16
initial setting 1-15
marking 1-1
multiple
parallel applications
1-16
one
end connected
example
4-11, 4-22
rating 4-11
middle connected
example
4-12, 4-23
rating 4-12
two
end connected
example
4-16
not end connected
example
4-18
segment between 4-10
power supply
current chart
end segment
KwikLink
4-5
rise time 1-15
power supply problems, diagnosing 5-7
power supply, tips for choosing 5-8
power usage
determining adequate power
4-3
powering output devices 1-1
DeviceNet power supply 4-1
noise protection 4-1
transient protection 4-1
PowerTap tap
description
2-9
diagram 2-9, 3-7
fusing 3-5
installing 3-5
schematic 2-9
preterminated cables
thick cable
2-16
thin cable 2-17
connecting to a DeviceBox tap
stripped conductors to micro fe-
male
2-18
stripped conductors to mini fe-
male
2-18
connecting to a DevicePort tap
micro male (90) to micro female
2-18
micro male (90) to mini female
2-18
connecting to a T-Port tap
mini male to micro female
2-17
mini male to mini female 2-17
problems, correcting and preventing 5-1