Configuration Guide Manual

Chapter 4 Configuring FactoryTalk Historian To Historian Interface
22 Rockwell Automation Publication H2H-IN001A-EN-E–July 2012
Since the Interface is local to the FactoryTalk Historian SE 3.01
Server, it will use the default proxy trust. If the Interface was
installed on a computer other than the Target Server, then you
would need to define a trust to allow a connection from that
computer to the Target Server.
NOTE
For more information on creating trusts, refer to the online help
available in the System Management Tools. To open it, under System
Management Tools, select Security > Mappings & Trusts, and click
on the toolbar.
Create application trusts for the following applications with the
piadmin user:
• FTPItoPI.exe
• FT-PE
NOTE
For more information on creating trusts, refer to the online help
available in the System Management Tools. To open it, under
System Management Tools, select Security > Mappings &
Trusts, and click on the toolbar.
To start the interface:
1. Go to Start > All Programs > Rockwell Software > FactoryTalk
Historian SE > Interface Configuration Utility. The Interface
Configuration Utility dialog box appears.
2. Under Interface, select the interface you have just created.
3. On the toolbar, click
.
The status of the interface at the bottom of the dialog box has
changed to Running.
Configure a Trust on the
Target Server
Configure a Trust on the
Source Server
Start the H2H Interface