Configuration Guide Manual

Rockwell Automation Publication H2H-IN001A-EN-E–July 2012 5
Chapter 1
Introduction
The FactoryTalk Historian To Historian Interface is used to
transfer data from a Rockwell Historian server (source server) to
another Rockwell Historian server (target server). This includes a
Rockwell FactoryTalk Historian ME module, a FactoryTalk
Historian SE server or a collective of FactoryTalk Historian SE 3.0
servers being transferred to another Rockwell FactoryTalk Historian
SE 3.0 server or a collective of FactoryTalk Historian SE 3.0 servers.
You will find here information about:
• Supported architectures (page 6).
• Licensing (page 9).
• Installing FactoryTalk Historian To Historian Interface (page
13).
• Configuring FactoryTalk Historian To Historian Interface
(page 19).
• Removing FactoryTalk Historian To Historian Interface
(page 29).
NOTE
For the latest information on the FactoryTalk Historian To
Historian Interface, please refer to the KB article 58662
(https://rockwellautomation.custhelp.com/app/answers/detail/
a_id/58662).
Individual components of the FactoryTalk Historian SE and
FactoryTalk family products may be referred to in this document
using the following abbreviations and naming conventions:
Terminology