Manual
11
Notes:
1> These signals must be run in a separate magnetic conduit to
minimize the possibility of noise pickup. (Refer to Table 7.B for
wire specifications.)
2> Remove the connection between SPEED pot and terminal 426
when AUTO/MANUAL switch is used.
3> Motors with dual voltage shunt fields should be connected for
the rated controller voltage.
4> Remove jumper J9 from Regulator Module when Reversing
Contactor is installed.
5> Use convenience terminals for #14 AWG maximum wire size.
6> If auxiliary Panel is not used, user must supply an appropriate
M contactor. Refer to Paragraphs 2.4.4 and I/M D3955.
+) ,, )(-+)&
)+
.-) ! + (
(*.-,
(,-+.' (- (- +!
)+
)&-" )&&)0 + $-
#)' - + % $-
#)' - +
2 +$/ )-)+
3ĆPHASE
PLANT POWER
)-
,0$-#
)
.' +
)-
)
.' +
,0$-#
,0$-#
,0$-#
$".+ 1,- ' )(( -$)( $"+'