Hardware Ref, Installation, and Troubleshooting User guide
7Ć1
7.0 WIRING THE REGULATOR BOARD TERMINAL
STRIP
This
chapter describes how to wire the Regulator board terminal strip for stop, speed feedback, and
remote control signals.
The terminal strip has the following signals available, as shown in figures 7.1 and 7.2. T
able 7.1
provides additional information. Note that when the Control Source parameter (P
.000) is set to remote
(rE), the drive will be controlled by the signals connected to the terminal strip. Refer to instruction
manual D2Ć3339 for more information on how parameter P
.000 is used to specify where the drive is
controlled from.
RSĆ232 Connections (Terminals 1Ć3)
D Terminal
1: T
ransmit (Tx)
D T
erminal 2: Receive (Rx)
D T
erminal 3: Regulator Common
The RS
Ć232 terminals should only be used when the RS
Ć232 communication port (J8) or an Operator
Interface module (OIM) is not
being used, as all three devices use the same transmit/receive lines.
Pulse Tachometer Connections (Terminals 4Ć9)
D Terminal 4: +15 VDC
D T
erminal 5: Phase A
D T
erminal 6: Phase A Not
D Terminal 7: Phase B
D Terminal 8: Phase B Not
D T
erminal 9: Regulator Common
A speed feedback device (pulse tachometer) must be installed if vector regulation (P
.048=1) is used.
Analog Output Connections (Terminals 10 and 11)
D Terminal
10: Analog Meter Output
D T
erminal 11: Regulator Common
The output of this terminal is either 0Ć10 VDC or 4Ć20 mA as determined by the setting of jumper J17
on the Regulator board. The analog output must also be programmed via parameter P
.012 for an
indication of speed and direction or percent of torque.
Analog
Speed/T
orque Reference Connections (Terminals 12Ć15)
D Terminal
12: Isolated Reference V
oltage
D Terminal 13: VDC Speed/T
orque Reference
D Terminal 14: mA Speed/T
orque Reference
D T
erminal 15: Isolated Reference Ground
The analog speed/torque (P
.008/U
.000) reference is either +/-10 VDC or +/-20 mA
, as determined
by the setting of jumper J4 on the Regulator board. The analog reference must also be programmed
via parameters P.009, P.010, and P.011.