Hardware Ref, Installation, and Troubleshooting User guide

AĆ2
Table A
.3 Ć T erminal Strip Input Specifications
Signal Type Terminal(s) Specification
Speed Reference Input 12Ć15 10 V (@ 50K ohm input
impedance or 20 mA)
Digital Inputs (1 Ć 8)
16 +24 VDĆC Isolated Supply
17 Remote/Local (Default)
18 Ramp1/Ramp2 (Default)
19 F orward/Reverse (Default)
20 F unction Loss
21 Run/Jog
22 Reset
23 Stop
24 Start
Table A .4 Ć T erminal Strip Output Specifications
Signal Type Terminal(s) Specification
Analog Output 10 Ć11
scaled signal
0Ć10 VDĆC or 4Ć20 mA
Snubber Resistor 26 Ć 27 Used with Snubber Resistor
Braking Kits Ć Refer to Instruction
Manual D2Ć3179.
Table A.5 Ć RS Ć232 Specifications
Signal Type Terminal(s) Specification
RS 232 Communications
1 XMIT
2 RECV
3 COMMON
Table A.6 Ć Speed F eedback Device Specifications (V ector Regulation Only)
Specification Rating
Motor P oles 2, 4, 6, or 8 poles
Overcurrent IET 200% load (based on drive nameplate rating)
Overload Current Rating 150% for 1 minute (based on drive nameplate rating)
Speed Control Range 1:600 with 1024 PPR
Speed Control Response 15 Hz (typical)
Speed Feedback 15 V differential quadrature, pulse tachometer
incremental (512 PPR, 1024 PPR, 2048 PPR,
4096 PPR)
Service F actor 1.0