Hardware Ref, Installation, and Troubleshooting User guide

CĆ1
Appendix C
Compliance with EN 60204Ć1: 1992
The GV3000 complies with the following sections of standard EN 60204Ć1: 1992.
EN60204Ć1
Section
Title
6 Protection against electrical shock
6.2.1 Ć Protection by enclosure
6.2.3 Ć Protection against residual voltages
6.3.1 Ć Protection by automatic disconnect of supply
6.4 Ć Protection by the use of PEL V (Protective Extra Low V oltage)
7 Protection of equipment
7.2 Ć Overcurrent protection
7.2.3 Ć Control circuits
7.2.6 Ć Transformers
7.5 Ć Protection against supply interruption or voltage reduction and subsequent restoration
8 Equipotential bonding
8.2.1 Ć General (the PE terminal)
8.2.2 Ć Protective conductors (connection points)
8.2.3 Ć Continuity of the protective bonding circuit
8.2.7 Ć Protective conductor connecting points
8.3 Ć Bonding to the protective bonding circuit for operational purposes
8.4 Ć Insulation failures
8.5 Ć Bonding to a common reference potential
8.6 Ć Electrical interferences
9 Control circuit and control functions
9.1.1 Ć Control circuit supply
9.1.3 Ć Protection
9.1.4 Ć Connection of control devices
9.2 Ć Control functions
9.2.1 Ć Start function
9.2.2 Ć Stop function
9.2.3 Ć Operating modes
9.2.5 Ć Operation
9.2.5.3 Ć Stop
9.2.5.6 Ć HoleĆtoĆrun controls
9.2.6 Ć Combined start and stop controls
9.3 Ć Protective interlocks
9.3.5 Ć Reverse current braking
9.4 Ć Control functions in case of failure
9.4.2.1 Ć Use of proven circuit techniques and components
9.4.3 Ć Provisions for redundancy
9.4.3.1 Ć Earth faults
9.4.3.2 ĆV oltage interruption