Specifications

6 SLC 500 Digital I/O Modules
Publication 1746-IN027D-EN-P - December 2012
Octal Label Kit Installation (for PLC processors only)
The octal label kit consists of an octal filter label and a door label. Use these octal labels to replace
the decimal labels that are attached to the I/O modules.
Apply the Octal Filter Label
1. Remove the octal filter label from its paper carrier.
2. Align the octal filter label numbers horizontally to the module color bar and over the
decimal filter numbers.
Refer to Installing Octal Labels on page 7 for filter label placement.
3. Apply the octal label to the filter.
4. Press firmly to be sure that the label adheres properly.
Apply the Octal Door Label
1. Remove the octal door label from its paper carrier.
2. Align the octal label directly over the decimal door label on the inside of the door.
Refer to Installing Octal Labels
on page 7 for door label placement.
3. Press firmly to be sure that the label adheres properly.
Removable Terminal Blocks
Colored terminal blocks are removable by loosening the upper and lower retaining screws. Black
terminal blocks are not removable.
TIP
The octal label kit can be obtained from your Allen-Bradley distributor. The octal
kit is ordered based on the catalog number of the I/O module.
Please refer to the SLC 500 Modular Hardware Style User Manual, publication
1747-UM011
, for a listing of octal label kit catalog numbers.
ATTENTION: Do not touch or remove the terminal block when the SLC 500 system is
powered. Contact with AC line potential may cause injury to personnel.