Installation manual
1 Publication 1747-RM001G-EN-P - November 2008
Chapter
 14
SLC Passthru Communications
There are three types of communications passthru (or bridging) supported by 
SLC 5/03, SLC 5/04 and SLC 5/05 processors.
• Remote I/O passthru via the 1747-SN and 1747-BSN remote I/O 
scanner modules
• DeviceNet passthru via the 1747-SDN DeviceNet scanner module
• Channel-to-channel passthru
The following table summarizes the processor OS firmware/passthru 
capability.
Remote I/O Passthru
This type of passthru allows the SLC processor system to act as a bridge 
between the channel 0 or channel 1 network, and the remote I/O network 
supported by the 1747-SN and 1747-BSN remote I/O scanner modules. This 
allows personal computers on Ethernet, DH+, DH-485 or DF1 networks to 
upload or download applications to devices such as PanelView operator 
terminals and power monitors on the remote I/O network.
Refer to the remote I/O device software documentation to get details on how 
to upload and download that device via remote I/O passthru
Table 14.1 Operating System (OS) Processor Firmware Required for Passthru Capability
Passthru 
Capability
Channel 0 
DH-485
Channel 0 DF1 
Full-duplex
Channel 0 
DF1-Half 
Duplex Master
Channel 0 DF1 
Radio Modem
Remote I/O 
(1747-SN/BSN)
DeviceNet 
(1747-SDN
(1)
)
Channel 1 
EtherNet
OS500 A FRN 1 OS500 A FRN 1 OS501 C FRN 6 OS501 C FRN 6 OS500 A FRN 1 OS500 A FRN 1
Channel 1 DH+ OS400 A FRN 1 OS401 A FRN 5 OS401 C FRN 6 OS401 C FRN 6 OS401 A FRN 5 OS400 A FRN 1
Channel 1 
DH-485
OS302 C FRN 7 OS302 C FRN 7 OS302 C FRN 7 OS302 C FRN 7 OS302 A FRN 9 OS300 A FRN 1
Remote I/O 
(1747-SN/BSN)
OS302 A FRN 9 OS302 A FRN 9 OS302 A FRN 9 OS302 C FRN 6 N/A N/A
OS401 A FRN 5 OS401 A FRN 5 OS401 A FRN 5 OS401 C FRN 6
OS500 A FRN 1 OS500 A FRN 1 OS500 A FRN 1 OS501 C FRN 6
DeviceNet 
(1747-SDN
(1)
)
OS300 A FRN 1 OS300 A FRN 1 OS302 A FRN 9 OS302 C FRN 6 N/A N/A
OS400 A FRN 1 OS400 A FRN 1 OS401 A FRN 5 OS401 C FRN 6
OS500 A FRN 1 OS500 A FRN 1 OS500 A FRN 1 OS501 C FRN 6
(1)
Requires FRN 4.015 or higher firmware.










