Installation manual

Publication 1747-RM001G-EN-P - November 2008
14-16 SLC Passthru Communications
If channel 0 is configured for DF1 Half-duplex Master, then the RSWho Poll
Timeout should be set to:
Channel 0 ACK Timeout * [1+ (2 * channel 0 message retries)]
If channel 0 of an SLC 5/05 is configured for DF1 Radio Modem, then the
RSWho Poll Timeout should be set the same as the Ethernet channel 1 MSG
Reply Timeout.
The RSWho Poll Timeout for known stations should be set to the time it takes
to poll the entire range of addresses.
Click OK and close RSWho (but you can leave RSLinx running). Start RSWho
again and now you should be able to browse through the passthru processor to
any remote nodes in the configured address range that are able to respond on
the half-duplex or radio modem network.
Figure 14.5 Passthru Processor in RSWho
TIP
Your passthru processor will show up as remote
node 0 when using RSWho, as shown below.
Therefore, it is a good idea to configure the
channel 0 node address of the passthru processor as
zero.