Installation manual

Publication 1747-RM001G-EN-P - November 2008
G-10 Application Example Programs
Drill Calculation and Warning
The program tracks the number of holes drilled and the number of inches of
material that have been drilled through using a thumbwheel. The thumbwheel
is set to the thickness of the book per 1/4 inch. (If the book is 1 1/2 inches
thick, the operator would set the thumbwheel to 6.) When 25,000 inches have
been drilled, the Change Drill Soon pilot light turns on. When 25,500 inches
have been drilled, the Change Drill Soon pilot light flashes. When 26,000
inches have been drilled, the Change Drill Now pilot light turns on and the
machine turns off. The operator changes drill bits and then resets the internal
drill wear counter by turning the Drill Change Reset keyswitch.
The following rung examines the number of 1/4" thousands that have accumulated over the life of the current
drill bit. If the bit has drilled between 100,000 and 101,999 1/4" increments of paper, then the "CHANGE
DRILL" light will illuminate steady. When the value is between 102,000 and 103,999, then the "CHANGE
DRILL" light will flash at a 1.28 second rate. When the value reaches 105,000, then the "CHANGE DRILL" light
will flash, and the "CHAGE DRILL NOW" light will illuminate.
0000
GEQ
Grtr Than or Eql (A>=B)
Source A N7:11
0<
Source B 100
100 <
GEQ B3:1
0
100,000 1/4"
Increments
Occured
GEQ
Grtr Than or Eql (A>=B)
Source A N7:11
0<
Source B 102
102 <
GEQ B3:1
1
102,000 1/4"
Increments
Occured
GEQ
Grtr Than or Eql (A>=B)
Source A N7:11
0<
Source B 105
105 <
GEQ O:3
6
1746-OA16
Change Drill Bit
Now!
B3:1
0
100,000 1/4"
Increments
Occured
B3:1
1
102,000 1/4"
Increments
Occured
B3:1
0
100,000 1/4"
Increments
Occured
B3:1
1
102,000 1/4"
Increments
Occured
S:4
7
Time Base
O:3
4
1746-OA16
Change Drill Bit
Soon!