Installation manual

Publication 1747-RM001G-EN-P - November 2008
G-16 Application Example Programs
On/Off Circuit Application
Example
The following application example illustrates how to use an input to toggle an
output either on or off. For a detailed explanation of:
• XIC, XIO, OTE, OTU, OTL, and OSR instructions, see Chapter 2.
• JMP and LBL instructions, see Chapter 6.
Table G.1 SQC Compare Data
Addresses Data (Radix = Decimal)
N7:0 0123456789
N7:10 0012345678
0006
C5:0 LES
Less Than (A<B)
Source A C5:0.ACC
0
0
Source B 150
LES
U
O:3
U
C5:0
If the high-speed counter reached its high preset of 350 (indicates that the holding area reached maximum capacity), it would energize O:0/0,
shutting down the filling operation. Before re-starting the filler, allow the packer to empty the holding area until it is about 1/3 full.
HSC Interr
due to
High Preset
IH
IH
HSC Interr due
to High Preset