Installation manual
Publication 1747-RM001G-EN-P - November 2008
Index 5
FRN 10 update A-19, A-21
FRN 6 update A-13
FRN 7 update A-15
FRN 9 update A-16
full-duplex station 13-51, 13-80
G
G data files E-25
editing G file data E-25
Global Status File B-59
Global Status Word 13-19, 13-20
overview 13-18
status file B-59
transmit enable bit 13-19
transmit receive bit 13-20
going-to-run errors 16-4
H
High-speed Counter (HSC) 2-15
addressing structure 2-16
application example 2-18, 2-19
counter instruction 2-15
I
I/O addressing
for a fixed controller
E-6
for a modular controller E-8
I/O Interrupt Disable (IID) 11-32
I/O interrupt instruction 11-32
I/O interrupt executing B-46
I/O interrupts 11-27
basic programming procedure 11-27
I/O Interrupt Disable (IID) 11-32
interrupt latency and interrupt
occurrences
11-28
interrupt priorities 11-29
operation 11-27
subroutine content (ISR) 11-28
incoming command pending (channel 0)
B-46
index address file range bit B-14
index register B-43
indexed addressing 4-2, D-1, E-10
example E-10
specifying E-10
indirect addressing 4-2, 5-16, D-1
inline indirection 10-21
input data file 1-2
input file E-2
instruction execution times - SLC
processors
C-2
fixed and SLC 5/01 processors C-2
SLC 5/02 processor C-7
SLC 5/03, 5/04, and 5/05 processors
C-13
instruction set D-1
integer file 1-10, 1-11, E-3
Integer to String (AIC) 10-14
ASCII instruction 10-14
interrupt latency 11-9, 11-21, 11-25,
11-28
interrupt latency control bit B-48
J
Jump (JMP)
entering parameters
6-2
using 6-2
Jump to Subroutine (JSR) 6-3
nesting subroutine files 6-4
using 6-4
L
Label (LBL)
entering parameters
6-2
using 6-3
last DII scan time B-57
LEDs 16-16
SLC 5/03 and SLC 5/04 LEDs 16-16
load memory module on memory error bit
B-8
local message 15-1
Log to the Base 10 (LOG) 4-31
math instruction 4-31
logical addresses, specifying
using mnemonics
E-6
M
M0 and M1 data files E-19
capturing M0-M1 file data E-24
minimizing the scan time E-22
specialty I/O modules with retentive
memory
E-24
transferring data between processor files
E-21
M0-M1 referenced or disabled slot bit
B-23
major error detected while executing
user fault routine bit
B-22